Safety Instructions; Avoid Unintended Start; Safe Stop - Danfoss VLT Automation Drive FC 300 Operating Instructions Manual

2. Safety Instructions and General Warning

2.1.2. Safety Instructions

• Make sure the frequency converter is properly connected to earth.
• Protect users against supply voltage.
2
• Protect the motor against overloading according to national and local regulations.
• Motor overload protection is not included in the default settings. To add this function, set parameter 1-90
ETR trip ETR warning
or
• The earth leakage current exceeds 3.5 mA.
• The [OFF] key is not a safety switch. It does not disconnect the frequency converter from mains.
2.1.3. General Warning
Warning:
Touching the electrical parts may be fatal - even after the equipment has been disconnected from mains.
Also make sure that other voltage inputs have been disconnected, such as load-sharing (linkage of DC intermediate circuit), as well as
the motor connection for kinetic back-up.
When using the frequency converter: wait at least 40 minutes.
Shorter time is allowed only if indicated on the nameplate for the specific unit.
Leakage Current
The earth leakage current from the frequency converter exceeds 3.5 mA. To ensure that the earth cable has a good mechanical
connection to the earth connection (terminal 95), the cable cross section must be at least 10 mm
separately. For proper earthing for EMC, see section
Residual Current Device
This product can cause a D.C. current in the protective conductor. Where a residual current device (RCD) is used for extra protection,
only an RCD of Type B (time delayed) shall be used on the supply side of this product. See also RCD Application Note MN.90.Gx.02
(x=version number).
Protective earthing of the frequency converter and the use of RCD's must always follow national and local regulations.
2.1.4. Before Commencing Repair Work
1. Disconnect the frequency converter from mains
2. Disconnect DC bus terminals 88 and 89 from load share applications
3. Wait for discharge of the DC-link. See period of time on the warning label
4. Remove motor cable

2.1.5. Avoid Unintended Start

While the frequency converter is connected to mains, the motor can be started/stopped using digital commands, bus commands,
references or via the Local Control Panel (LCP):
• Disconnect the frequency converter from mains whenever personal safety considerations make it necessary to avoid unintended start.
• To avoid unintended start, always activate the [OFF] key before changing parameters.
• An electronic fault, temporary overload, a fault in the mains supply, or lost motor connection may cause a stopped motor to start. The frequency
converter with Safe Stop provides protection against unintended start, if the Safe Stop Terminal 37 is deactivated or disconnected.

2.1.6. Safe Stop

The FC 302 can perform the safety function
It is designed and approved suitable for the requirements of Safety Category 3 in EN 954-1. This functionality is called Safe Stop. Prior to integration and
use of Safe Stop in an installation, a thorough risk analysis on the installation must be carried out in order to determine whether the Safe Stop functionality
and safety category are appropriate and sufficient. In order to install and use the Safe Stop function in accordance with the requirements of Safety
Category 3 in EN 954-1, the related information and instructions of the FC 300 Design Guide MG.33.BX.YY must be followed! The information and
instructions of the Operating Instructions are not sufficient for a correct and safe use of the Safe Stop functionality!
8
. For the North American market: ETR functions provide class 20 motor overload protection, in accordance with NEC.
Safe Torque Off
(As defined by draft CD IEC 61800-5-2) or
MG.33.U2.02 - VLT
Operating Instructions High Power
Earthing How to Install
in the chapter.
Stop Category 0
® is a registered Danfoss trademark
®
VLT Automation Drive FC 300
Motor thermal protection
to value
2
or 2 rated earth wires terminated
(as defined in EN 60204-1).