Move The Configuration Files Back To The Xli - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S
• The configuration files are automatically transferred to/from the FTP server in binary format.
They retain the DOS or UNIX file conventions of the editor. XLi works with either format.

Move the Configuration Files Back to the XLi

Reboot Warning: The following steps cause the XLi to reboot.
Using the XLi's command line, enter one of the commands below, replacing
<IP Address> with the IP address of your workstation/FTP server.
To move the SNMP config file, type:
>f100 config snmp set host:<IP Address> dir:<subdir>
Here's an example of a successful SNMP config file transfer:
>>f100 config set snmp host:192.168.0.1 dir:
Host config ip 192.168.0.1 already configured
Are you sure(y/N)?y
Source file snmp.conf bytes read: 1275
Dest file /config/snmp.conf bytes written: 1275
Configuration files transferred successfully!
Resetting...
If you get "Error: Can't open source file", verify that the FTP server's <<Local Server>> is
running.
After XLi receives the configuration files, it reboots, and goes through the normal startup process.
End of Procedure
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S S S S S S S S S S S S S S S S S S S S S S S
2
1
5
S S S S
143