Symmetricom XLi IEEE 1588 User Manual page 131

S S S S S S S S S
• Use the ENTER key to continue to the next screen.
• When prompted with "SAVE CHANGES? YES", press the ENTER key.
To use F131, press the following keys on the front panel keypad:
ENTER 131 ENTER
The keypad display interface displays the following sequence of screens:
• PTP AVAILABILITY - OPTION BAY #
• READING PTP OPTION CARD - PLEASE WAIT 5 SECONDS
• PTP IP ADDRESS (STATIC)
- For PTP master, Option Bay 4 - 010.048.000.103
- For optional PTP slave, Option Bay 2 - 010.048.000.105
• PTP SUBNET MASK (STATIC) - 255.255.000.000 (Range:0 to 255 for each 3 digit address.)
• PTP DEFAULT GATEWAY (STATIC) - 010.024.000.001 (Range:0 to 255 for each 3-digit
address.)
• PTP DHCP - ENABLE (or DISABLE or DHCP) (if enabled, the next three screens provide the IP
Address, Subnet Mask, and Gateway assigned by the DHCP server.)
• PTP SYNC INTERVAL - 2 (or 1, 8, 16, 64)
• PTP BURST MODE - DISABLE (or ENABLE)
• PTP PORT STATE - ENABLE (or DISABLE)
• PTP SUBDOMAIN NAME - _DFLT (or _ALT1, _ALT2, _ALT3)
• PTP RESET TO FACTORY DFLT? - NO (or YES)
• PTP INIT TO USER SETTINGS? - NO (or YES)
• PTP CLOCK CONFIG, BAY 2 - MASTER (or SLAVE PRI, SLAVE SEC, SLAVE STBY)
• SLAVE SYNC THRESHOLD - 5 microsec (or 1000 microsec)
• PTP PREFERRED MASTER - DISABLE (or ENABLE)
• SAVE CHANGES? - YES (or NO)
In the list above, factory settings are in italics, and factory defaults are in bold italics.
Command Line
The following list is a summary of the F131 commands:
Request a summary of all PTP settings:
F131 B<N>
>F131 B4
ERROR: INVALID COMMAND!
1. Only displayed when PTP CLOCK CONFIG, BAY # is SLAVE PRI/SEC/STBY
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S S S S S S S S S S S S S S S S S S S S S S
2
1
1
5
S S S S S
123