Request The Ptp Preferred Master Clock Configuration; Enable Or Disable The Ptp Preferred Master Clock Configuration; F131 B<N> S<Cr> Request Ptp Network Parameters Status - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S

Request the PTP Preferred Master Clock Configuration

Use this command to review the PTP Preferred Master Clock configuration settings. To obtain the PTP
Preferred Master Clock configuration setting, use the following format:
F131 B<N> C<CR>
For example, enter:
F131 B4 PM
Response (example):
F131 B4 PM ENABLE<CR><LF>

Enable or Disable the PTP Preferred Master Clock Configuration

Use this command to enable or disable the PTP Preferred Master clock configuration settings. To set the
PTP Preferred Master clock configuration, use the following format:
F131 B<N><SP>PM<SP><CONFIG>
where:
F = ASCII character F
131 = unit function number
<SP> = space
B = ASCII letter to denote Option Bay number follows
<N> = Option Bay Number, 1 through 4.
PM = specify PTP Preferred Master command
<CONFIG> = ENABLE or DISABLE.
For example, enter:
F131 B4 PM ENABLE
Response (one of the following lines):
OK - Preferred Master Clock Config has been received and applied by the PTP Option
Card
Request PTP Network Parameter Status
Use Serial/Network port F131 B<N> S command to review all of the PTP Option Card Protocol
Parameters status. To obtain the PTP Network Parameters status, send the following command to the
XLi serial/network port:
134
S S S S S S S S S S S S S S S S S S S S S S S S S S S
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S