Symmetricom XLi IEEE 1588 User Manual page 44

S S S S S S S S S
F66 – Daylight Saving Time (DST)
Mode
F69 – Time Mode
F71 – Oscillator Statistics
F72 – Fault Status
F73 – Alarm Control / Status
F74 – Clock Source Control
F90 – Code Output Configuration
F100 – Network Port Configuration &
XLi Firmware
F100 EA – Ethernet Address
F100 IP – IP Address
F100 SM – Subnet Mask
F100 G – Gateway
F100 IC – Network Port Settings
F100 L/LOCK/UNLOCK – Remote
Lockout
F100 L – Remote Lockout
F100 ST – Self Test Status
F100 BH – Burn Host
F100 BUB – Burn BootLoader
F100 BU – Burn
F100 BF – Burn File System
F100 BUFP – Burn FPGA Firmware
F100 CONFIG – Configure NTP &
SNMP
F100 J – Factory Mode Jumper
36
S S S S S S S S S
K,N,S,W Schedule when DST starts and ends (Local time only)
K,N,S,W Set the time scale (TAI, GPS, UTC, Standard, Local) output
K,N,S,W Display the XLi oscillator's phase, offset, drift, and DAC
K,N,S,W View clock and power supply fault status
K,N,S,W View the status of all the alarm indicators. Enable/disable
K,N,S,W Select the pattern of switching between reference sources
K,N,S,W Configure settings for CODE – time code output
K,N,S,W Configure the standard network port settings
K,N,S,W Display the Ethernet (MAC) address
K,N,S,W Configure the IP address
K,N,S,W Configure the subnet mask
K,N,S,W Configure the default gateway
K,N,S,W Display all the standard network port's settings
K,N,S
K,N*,S
K,N,S
N,S
N,S
N,S
N,S
N,S
N,S,W*
N,S
S S S S S S S S
by the IEEE 1588 card and displayed on the front panel of
the XLi. (TAI is the recommended setting).
values
alarms for each indicator. Set alarm thresholds. Enable or
disable LED blink
Lock remote access to the XLi's standard network port
Display the status of F100 LOCK
*Locked through the network port, serial port, and keypad.
Can be unlocked only through the keypad or serial port.
Display the XLi's self test results for Flash CRC, RAM,
Serial Port, and NVRAM
Upgrading system firmware: select the FTP host, path, and
filename of the system firmware
Upgrading system firmware: 'burn' the bootloader file (*.bt)
selected using F100 BH to flash memory
Upgrading system firmware: 'burn' the system firmware file
(*.bin) selected using F100 BH to flash memory
Upgrading system firmware: 'burn' the file system file (*.fs)
selected using F100 BH to flash memory
Upgrading system firmware: burn the FPGA program file
(*.bin) selected using F100 BH to the flash memory
Transfer the SNMP configuration file between the XLi and
a
an FTP server for editing
View the status of the factory mode jumper, which is used
by factory technicians. Not of interest to most end users.
S S S S S S S S S
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S