Get Ptp Protocol Settings - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S
where:
F = ASCII character F
131 = unit function number
<SP> = space
B = ASCII letter to denote Option Bay number follows
<N> = Option Bay Number, 1 through 4.
DHCP = specify Dynamic Host Configuration Protocol command
<SET> = ENABLE or DISABLE
For example, enter:
F131 B4 DHCP ENABLE
Response (one of the following lines):
OK - DHCP enable setting has been received and applied by the PTP Option Card<CR><LF>
ERROR - DHCP dynamic setting request has Failed.
ERROR - DHCP dynamic settings has Failed, using Static IP.

Get PTP Protocol settings

To get PTP protocol settings, use the following format:
F131 B<N> PROTOCOL<CR>
For example, enter:
F131 B4 PROTOCOL
Response:
F131 B4 PROTOCOL 27 ENABLE ENABLE<CR><LF>
To set the PTP protocol settings, use the following format:
F131 B<N><SP>PROTOCOL<SP><SI><SP><BS><SP><PS>
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S S S S S
(or DISABLE)
S S S S S S S S S S S S S S S S S S
2
1
5
S S S S
129