F100 Bh - Burn Host; F100 Bub - Burn Bootloader - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S
where:
= ASCII character F
F
= Unit function number
100
= Space
<S>
= Specify ST command
ST
FLASH/CRC: = Specify flash checksum result
= Specify RAM test result
RAM:
= Specify Serial Port test result.
SERIAL:
NVRAM VER: = Specify version test result. This test compares the version of the code against the version
recorded in Non-Volatile memory
= Is either ASCII PASS or FAIL
<STATUS>
= ASCII comma
,
= ASCII colon
:
= Output line terminator
<CR><LF>
An example of the response is:
F100 ST FLASH/CRC : PASS, RAM : PASS, SERIAL : PASS, NVRAM VER : PASS<CR><LF>
F100 BH – Burn Host
Use function F100 BH, when upgrading firmware, to select the FTP host and the file to be transferred.
To select the FTP host and file for upgrading, enter:
F100 BH <FTP HOST IP ADDRESS><S><UPGRADE FILE PATH>/<FILE NAME><CR>
Use UNIX style forward slashes '/' in path and leave the drive letter (e.g., 'C') out of the path.
For example:
F100 BH 10.1.7.20 truetime/xli/192-8001.bin<CR>
The XLi responds:
BURN HOST IS READY!!!<CR><LF>
F100 BUB – Burn BootLoader
Note:
See "B: Upgrading System Firmware" on page 145.
When upgrading the system firmware, use function F100 BUB to burn the BootLoader, to write the
BootLoader to flash memory.
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S S S S S S S S S S S S S S S S S S S S S S S
2
1
5
S S S S
89