Symmetricom XLi IEEE 1588 User Manual page 166

S S S S S S S S S
sea level."
::= { gps 6 }
gpsLongitude OBJECT-TYPE
SYNTAX INTEGER (-2147483647..2147483647)
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION
"Longitude location of GPS antenna where: +2147483647 is
maximum east longitude, -2147483647 is maximum west longitude and 0 is
Greenwich England.
following formula (gpsLongitude * PI) / ((2^31)-1) = longitude in
radians. For degrees: (gpsLongitude * 180) / ((2^31)-1) = longitude
in degrees.
-180 to +180 in degrees."
::= { gps 7 }
gpsLatitude OBJECT-TYPE
SYNTAX INTEGER (-2147483647..2147483647)
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION
"Latitude location of GPS antenna where: +2147483647 is the
North Pole, -2147483647 is the South Pole and 0 is the equator. To
calculate the latitude in radians use the following formula
(gpsLatitude * PI) / (2*((2^31)-1)) = longitude in radians.
degrees: (gpsLatitude * 90) / ((2^31)-1) = latitude in degrees.
Note: latitude varies from -PI/2 to +PI/2 in radians and -90 to +90 in
degrees."
::= { gps 8 }
actsGroupValid OBJECT-TYPE
SYNTAX INTEGER (0..1)
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION
"A test flag indicating if data contained in this SNMP ACTS group is
valid or not.
synchronization source and 0 for all other sources.
::= { acts 1 }
actsBaudRate OBJECT-TYPE
SYNTAX INTEGER
{
}
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION
"Indicates the baud rate setting for the ACTS modem.
dial-up service accepts 300 or 1200 baud.
where faster is not better and 300 baud yields the best time accuracy."
158
S S S S S S S S
To calculate the longitude in radians use the
Note: longitude varies from -PI to +PI in radians and
This flag equals 1 when ACTS is used as the time
baud300 (300),
baud1200 (1200),
baud9600 (9600)
S S S S S S S S S
Note: this is a rare case
S S S S S S S S S
For
"
The ACTS
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S