Table of Contents
Advertisement
S
S
S
S
S
S
S
S
S
settings, alarms, and SNMP).
•
System I/O - the status and configuration of the input and output connectors on the rear of the
main CPU card (e.g., communication settings, code out, J1, J2, and J3).
•
Subsystem - configuration of the option cards located in the option bays
Under Subsystem, the XLi names CPU-aware option cards to the right of the option bay where they are
located. Non-CPU aware cards can be present and fully operational in an option bay, but are not shown
in the web interface. For more information, see
Only option bays with CPU-aware option cards will have active links. Clicking the link of an unpopulated
or non-existent option bay simply refreshes the web page.
When clicking on links, allow each page to load before clicking another link. Clicking links too quickly
may cause the Login page to appear.
Submitting Changes
When submitting changes, only click the Submit Changes button once. Wait for the web page to load
before navigating away from the page or submitting another change.
Logging Out
To log out, click the Logout button located in the upper left corner of the page.
If the user closes the browser without logging out, a new session will not be available until the XLi closes
the inactive session after 30 minutes.
Notes
Notes for specific pages in the web interface:
•
Units equipped with the GPS C/A Receiver (87-8028-2): When the user changes the M12 GPS
Mode setting and applies the changes, the GPS C/A Receiver goes through several states
before attaining the user-specified mode.
•
Change Login Page: To change the Operator name, but not the password, leave the password
field blank and submit the change.
•
The NTP option, though mentioned in the Web Interface, is currently unavailable for the standard
XLi IEEE 1588 clock.
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
F118 – Option Board Configuration (page
S
S
S
S
S
S
S
S
S
108).
2
1
5
S
S
S
S
S
33
Advertisement
Table of Contents
