Request The Ptp Subdomain Name; Set The Ptp Subdomain Name - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S
where:
F = ASCII character F
131 = unit function number
<SP> = space
B = ASCII letter to denote Option Bay number follows
<N> = Option Bay Number, 1 through 4.
PROTOCOL = specify PTP Protocol command
<SI> = Sync Interval in seconds, 1, 2, 8, 16 and 64
<BS> = Burst Setting, ENABLE or DISABLE
<PO> = PTP Port Setting, ENABLE or DISABLE
For example, enter:
F131 B4 PROTOCOL 16 ENABLE DISABLE
Response (one of the following lines):
OK - Protocol Settings have been received and applied by the PTP Option Card<CR><LF>

Request the PTP Subdomain Name

To request the PTP Subdomain Name, use the following format:
F131 B<N> SDN<CR>
For example, enter:
F131 B4 SDN
Response (example):
F131 B4 SDN _DFLT <CR><LF>

Set the PTP Subdomain Name

To set the PTP Subdomain Name, use the following format:
F131<SP>B<N><SP>SDN<SP>SUBDOMAIN
130
S S S S S S S S S S S S S S S S S S S S S S S S S S S
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S