5: Function Reference; Function Summary - Symmetricom XLi IEEE 1588 User Manual

S S S S S S S S S

5: Function Reference

Function Summary

The following summary lists all the XLi functions, identifies the user interfaces from which each one is
available, and provides a brief description of the function.
Available from: K = keypad, N = Network Port (Telnet), S = Serial Port, W = Web
Function
F1 – Time Zone Offset
F2 – 12/24 Hour Format
F3 – Time & Date
F4 – Serial Port Configuration
F5 – Time-Quality Setup
F6 – Keypad Lock
F8 - Continuous Time Once-per-
Second
F9 - Time On Request
F11 - Time Output Format
F13 – Time Error
F18 – Software Version Request
F27 – FTM III Configuration
F42 – Multicode Output Configuration
F44 – N.8 Frequency Synthesizer
F50 – GPS Receiver LLA/XYZ Position
F51 – GPS Antenna Cable Delay
F52 – Distribution Cable Delay
F53 – GPS Operation Mode
F60 – GPS Receiver Satellite List
XLi IEEE 1588 Clock
997-01510-03, Rev. C, 12/12/2006
S S S S S S S S S
Available
From
K,N,S,W Set the time offset for Standard and Local time
K,N,S,W Apply a 12 or 24-hour format to the Front Panel Display, to
K,N,S,W Set the time and date (when not already provided by a
K,N,W
K,N,S,W Set the thresholds for each of the four time quality flags
K*,N,S
N,S
N,S
N,S
K,N,S,W View the current estimated worst case time error
K,N,S,W View the XLi's software version information
K,N,S,W Not supported.
K,N,S,W Not supported.
K,N,S,W Not supported.
K,N,S,W View the Latitude/Longitude/Altitude or geocentric X/Y/Z
K,N,S,W Compensate for the delay caused by the length of the GPS
K,N,S,W Compensate for the length of the distribution cable on J2.
K,N,S,W Operate specific GPS receivers in Time Mode for static
K,N,S,W View a list of current and tracked satellites.
S S S S S S S S S
Description
F8, F9, and F90.
reference source)
Configure the main serial port settings
Lock keypad access to the XLi's functions. (When locked,
F6 is the only function available from the keypad.)
Output the time once-per-second (to the command line)
Output the time when triggered (to the command line)
Change the format of the time output by F8 and F9
coordinates of one or more GPS antennas.
antenna cable. (Use F52 to adjust timing outputs .)
applications, or in Dynamic Mode for mobile applications.
S S S S S S S S S
2
1
5
S S S S
35