Configuring Synchronous Information Output - H3C S3100V2-52TP Configuration Manual

To do...
Uploading
the
security
log file to
the SFTP
server

Configuring synchronous information output

With synchronous information output enabled, if a user's input is interrupted by system output such as log,
trap, or debugging information, then after the completion of system output the system will display a
command line prompt (a prompt in command editing mode, or a [Y/N] string in interaction mode) and
the input so far.
The advantage of this feature is that when your input is interrupted by a large amount of system output,
you can continue your operations from where you were stopped.
Follow these steps to enable synchronous information output:
To do...
Enter system view
Establish an SFTP
connection in an IPv4
network environment
Establish an SFTP
connection in an IPv6
network environment
Upload a file on the
client to the remote SFTP
server
Download a file from a
remote SFTP server and
save it
All other operations
supported by the device
acting as an SFTP client
Use the command...
system-view
Use the command...
sftp server [ port-number ]
[ identity-key { dsa | rsa } |
prefer-ctos-cipher { 3des |
aes128 | des } |
prefer-ctos-hmac { md5 |
md5-96 | sha1 | sha1-96 } |
prefer-kex
{ dh-group-exchange |
dh-group1 | dh-group14 } |
prefer-stoc-cipher { 3des |
aes128 | des } |
prefer-stoc-hmac { md5 |
md5-96 | sha1 | sha1-96 } ] *
sftp server [ port-number ]
[ identity-key { dsa | rsa } |
prefer-ctos-cipher { 3des |
aes128 | des } |
prefer-ctos-hmac { md5 |
md5-96 | sha1 | sha1-96 } |
prefer-kex
{ dh-group-exchange |
dh-group1 | dh-group14 } |
prefer-stoc-cipher { 3des |
aes128 | des } |
prefer-stoc-hmac { md5 |
md5-96 | sha1 | sha1-96 } ] *
put localfile [ remotefile ]
get remotefile [ localfile ]
See Security Configuration
Guide.
50
Remarks
Optional
The sftp commands are available in
user view; the other commands are
available in SFTP client view.
For more information about these
commands, see Security Command
Reference.
Remarks
—