Configuring Dhcp Tests - H3C S3100V2-52TP Configuration Manual

To do...
Configure the source interface for
ICMP echo requests
Configure the source IP address of
ICMP echo requests
Configure the next hop IP address
of ICMP echo requests
Configure optional parameters
NOTE:
NQA ICMP echo tests are not supported in IPv6 networks. To test the reachability of an IPv6 address, use
the ping ipv6 command. For more information about the command, see
Monitoring Command Reference.

Configuring DHCP tests

DHCP tests of an NQA test group are used to test if a DHCP server is on the network, and the time for
the DHCP server to respond to a client request and assign an IP address to the client.
Configuration prerequisites
Before you start DHCP tests, configure the DHCP server. If the NQA (DHCP client) and the DHCP server
are not in the same network segment, configure a DHCP relay. For the configuration of DHCP server and
DHCP relay, see Layer 3
Configuring DHCP tests
Follow these steps to configure DHCP tests:
To do...
Enter system view
Use the command...
source interface
interface-type
interface-number
source ip ip-address
next-hop ip-address
See "Configuring
optional parameters for
an NQA test
IP Services Configuration Guide.
—
Use the command...
system-view
120
Remarks
Optional
By default, no source interface is configured
for probe packets.
The requests take the IP address of the
source interface as their source IP address
when no source IP address is specified.
The specified source interface must be up;
otherwise, no ICMP echo requests can be
sent out.
Optional
By default, no source IP address is
configured.
If you configure both the source ip command
and the source interface command, the
source ip command takes effect.
The source IP address must be the IP address
of a local interface. The local interface must
be up; otherwise, no ICMP echo requests
can be sent out.
Optional
By default, no next hop IP address is
configured.
Optional
group"
Remarks
—
Network Management and