Snmp Logging Configuration Example - H3C S3100V2-52TP Configuration Manual

SNMP logging configuration example

Network requirements
An SNMP agent (1.1.1.1/24) connects to an NMS (1.1.1.2/24) over Ethernet, as shown in
Configure the agent to log the SNMP operations performed by the NMS.
Figure 27 Network diagram
Configuration procedure
NOTE:
This configuration example assumes that you have configured all required SNMP settings for the NMS
and the agent (see
example.").
# Enable displaying log messages on the configuration terminal. (This function is enabled by default.
Skip this step if you are using the default.)
<Agent> terminal monitor
<Agent> terminal logging
# Enable the information center to output the system events of the informational or higher severity to the
console port.
<Agent> system-view
[Agent] info-center source snmp channel console log level informational
# Enable logging Get and Set operations.
[Agent] snmp-agent log all
# Verify the configuration.
Use the NMS to get a MIB variable from the agent. The following is a sample log message
•
displayed on the configuration terminal:
%Jan 1 02:49:40:566 2011 Sysname SNMP/6/GET:
seqNO = <10> srcIP = <1.1.1.2> op = <get> node = <sysName(1.3.6.1.2.1.1.5.0)> value=<>
Use the NMS to set a MIB variable on the agent. The following is a sample log message displayed
•
on the configuration terminal:
%Jan 1 02:59:42:576 2011 Sysname SNMP/6/SET:
seqNO = <11> srcIP = <1.1.1.2> op = <set> errorIndex = <0> errorStatus =<noError> node
= <sysName(1.3.6.1.2.1.1.5.0)> value = <Agent>
"SNMPv1/SNMPv2c configuration example" and
71
Figure
"SNMPv3 configuration
27.