Configuring The Cwmp Connection Interface; Sending Inform Messages - H3C S3100V2-52TP Configuration Manual

Network management and monitoring
Hide thumbs Also See for S3100V2-52TP:
Table of Contents

Advertisement

Configuring the CWMP connection interface

A CWMP connection interface is an interface that connects a CPE to the ACS. The CPE sends an Inform
message carrying the IP address of the CWMP connection interface, and asks the ACS to establish a
connection through this IP address; the ACS will reply the CPE with a response message to this IP
address.
Generally, the system automatically obtains a CWMP connection interface through a certain mechanism.
However, if the obtained interface is not the one that connects the CPE to the ACS, the CWMP
connection will fail to be established. In this case, you need to specify the CWMP connection interface
manually.
Follow these steps to configure a CWMP connection interface:
To do...
Enter system view
Enter CWMP view
Set the interface that connects the
CPE to the ACS

Sending Inform messages

Inform messages need to be sent during the connection establishment between a CPE and an ACS. You
can configure the Inform message sending parameter to trigger the CPE to initiate a connection to the
ACS.
Sending an Inform message periodically
Follow these steps to configure the CPE to periodically send Inform messages:
To do...
Enter system view
Enter CWMP view
Enable the periodical sending of
Inform messages
Configure the interval between
sending the Inform messages
Sending an Inform message at a specific time
Follow these steps to configure the CPE to send an Inform message at a specific time:
To do...
Enter system view
Enter CWMP view
Use the command...
system-view
cwmp
cwmp cpe connect interface
interface-type interface-number
Use the command...
system-view
cwmp
cwmp cpe inform interval enable
cwmp cpe inform interval seconds
Use the command...
system-view
cwmp
200
Remarks
Required
By default, the interface that
connects the CPE to the ACS is
VLAN-interface 1.
Remarks
Required
Disabled by default
Optional
By default, the CPE sends an Inform
message every 600 seconds.
Remarks

Advertisement

Table of Contents
loading

Table of Contents