Configuring Cpe Attributes; Configuring The Cpe Username And Password - H3C S3100V2-52TP Configuration Manual

To do...
Configure the ACS password for
connection to the ACS
NOTE:
Make sure that the configured username and password are the same as those configured for the CPE on
the ACS; otherwise, the CPE cannot pass the ACS authentication.

Configuring CPE attributes

CPE attributes include CPE username and password, which are used by a CPE to authenticate an ACS.
When an ACS initiates a connection to a CPE, the ACS sends a session request carrying the CPE URL,
username, and password. When the switch (CPE) receives the request, it compares the CPE URL,
username, and password with those configured locally. If they are the same, the ACS passes the
authentication of the CPE, and the connection establishment proceeds. Otherwise, the authentication
fails, and the connection establishment is terminated.

Configuring the CPE username and password

Follow these steps to configure the CPE username and password:
To do...
Enter system view
Enter CWMP view
Configure the CPE username for
connection to the CPE
Configure the CPE password for
connection to the CPE
Use the command...
cwmp acs password password
Use the command...
system-view
cwmp
cwmp cpe username username
cwmp cpe password password
199
Remarks
Optional
You can specify a username
without a password that is used in
the authentication. If so, the
configuration on the ACS and that
on the CPE must be the same.
By default, no ACS password is
configured for connection to the
ACS.
Remarks
—
—
Required
By default, no CPE username is
configured for connection to the
CPE.
Optional
You can specify a username
without a password that is used in
the authentication. If so, the
configuration on the ACS and that
on the CPE must be the same.
By default, no CPE password is
configured for connection to the
CPE.