Configuring Udp Echo Tests - H3C S3100V2-52TP Configuration Manual

To do...
Enter system view
Enter NQA test group
view
Configure the test type as
TCP, and enter test type
view
Configure the destination
address of TCP probe
packets
Configure the destination
port of TCP probe packets
Configure the source IP
address of TCP probe
packets
Configure optional
parameters

Configuring UDP echo tests

UDP echo tests of an NQA test group are used to test the connectivity and round-trip time of a UDP packet
from the client to the specified UDP port on the NQA server.
Configuration prerequisites
UDP echo tests require cooperation between the NQA server and the NQA client. Before you start UDP
echo tests, configure a UDP listening service on the NQA server. For more information about the UDP
listening service configuration, see
Configuring UDP echo tests
Follow these steps to configure UDP echo tests:
To do...
Enter system view
Enter NQA test group view
Configure the test type as UDP
echo, and enter test type view
Use the command...
system-view
nqa entry admin-name
operation-tag
type tcp
destination ip ip-address
destination port
port-number
source ip ip-address
See "Configuring optional
parameters for an NQA
test group"
"Configuring the NQA
Use the command...
system-view
nqa entry admin-name
operation-tag
type udp-echo
127
Remarks
—
—
Required
Required
By default, no destination IP address is configured.
The destination address must be the same as the IP
address of the listening service configured on the
NQA server.
Required
By default, no destination port number is
configured.
The destination port number must be the same as
that of the listening service on the NQA server.
Optional
By default, no source IP address is specified.
The source IP address must be the IP address of a
local interface. The local interface must be up;
otherwise, no probe packets can be sent out.
Optional
server."
Remarks
—
—
Required