Configuring The Maximum Number Of Attempts Made To Retry A Connection; Configuring The Close-Wait Timer Of The Cpe - H3C S3100V2-52TP Configuration Manual

To do...
Configure the CPE to send an
Inform message at the specified
time
Configuring the maximum number of attempts made to retry a
connection
If a CPE fails to establish a connection to an ACS, or the connection is interrupted during the session (the
CPE does not receive a message indicating the normal close of the session), the CPE can automatically
reinitiate a connection to the ACS.
Follow these steps to configure the maximum number of attempts that a CPE can make to retry a
connection:
To do...
Enter system view
Enter CWMP view
Configure the maximum number of
attempts that a CPE can make to
retry a connection

Configuring the close-wait timer of the CPE

The close-wait timeout is used mainly in the following two cases:
• During the establishment of a connection: If the CPE sends connection requests to the ACS, but the
CPE does not receive a response within the configured close-wait timeout, the CPE will consider the
connection failed.
After a connection is established: If there is no packet interaction between the CPE and ACS within
•
the configured close-wait timeout, the CPE will consider the connection invalid, and disconnect the
connection.
Follow these steps to configure the close wait timer of a CPE:
To do...
Enter system view
Enter CWMP view
Configure the timeout value of the
CPE close-wait timer
Use the command...
cwmp cpe inform time time
Use the command...
system-view
cwmp
cwmp cpe connect retry times
Use the command...
system-view
cwmp
cwmp cpe wait timeout seconds
201
Remarks
Required
By default, the time is null, that is,
the CPE is not configured to send
an Inform message at a specific
time.
Remarks
—
—
Optional
Infinity by default, that is, a CPE
sends connection request s to the
ACS at a specified interval all
along.
Remarks
—
—
Optional
30 seconds by default