Configuring Synchronous Information Output - H3C S5120-SI Series Operation Manual

Use this feature to control whether to output system information to the Web interface and which system
information can be output to the Web interface. The Web interface provides abundant search and
sorting functions, therefore, if you configure to output the system information to the Web interface, you
can view system information by clicking corresponding tabs after logging in to the device through the
Web interface.
Follow these steps to set to output system information to the Web interface:
To do...
Enter system view
Enable information center
Name the channel with a
specified channel number
Configure the channel through
which system information can
be output to the Web interface
Configure the output rules of
the system information
Configure the format of the
timestamp
You can configure to output log, trap and debugging information to a channel, but when this channel is
bound with the output destination Web interface, after logging in through the Web interface, you can
view log information of specific types only, and other types of information will be filtered out.

Configuring Synchronous Information Output

Synchronous information output refers to the feature that if the user's input is interrupted by system
output such as log, trap, or debugging information, then after the completion of system output the
system will display a command line prompt (a prompt in command editing mode, or a [Y/N] string in
interaction mode) and your input so far.
This command is used in the case that your input is interrupted by a large amount of system output.
With this feature enabled, you can continue your operations from where you were stopped.
Use the command...
system-view
info-center enable
info-center channel
channel-number name
channel-name
info-center syslog channel
{ channel-number |
channel-name }
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state }* | log
{ level severity | state state }* |
trap { level severity | state
state }* ]*
info-center timestamp
{ debugging | log | trap }
{ boot | date | none }
1-13
Remarks
—
Optional
Enabled by default
Optional
Refer to Table 1-2 for default
channel names.
Optional
By default, system information
is output to the Web interface
through channel 6.
Optional
Refer to Default Output Rules
of System .
Optional
The time stamp format for log,
trap and debugging information
is date by default.