Configuring Http Tests - H3C S3100V2-52TP Configuration Manual

To do...
Configure optional parameters
NOTE:
When you execute the put command, the NQA client creates a file named
•
FTP server. The
get command, the client does not save the files obtained from the FTP server.
• When you get a file that does not exist on the FTP server, FTP tests fail.
When you perform an FTP test, use a small file and set a long NQA probe timeout time. A big file or
short probe timeout time may result in probe timeout.

Configuring HTTP tests

HTTP tests of an NQA test group are used to test the connection between the NQA client and an HTTP
server, and the time required to obtain data from the HTTP server. HTTP tests enable you to detect the
connectivity and performance of the HTTP server.
Configuration prerequisites
Before you start HTTP tests, configure the HTTP server.
Configuring HTTP tests
Follow these steps to configure HTTP tests:
To do...
Enter system view
Enter NQA test group view
Configure the test type as HTTP,
and enter test type view
Configure the IP address of the
HTTP server as the destination
address of HTTP request packets
Configure the source IP address of
request packets
Configure the operation type
Configure the website that an HTTP
test visits
Use the command...
See "Configuring
optional parameters for
an NQA test
file-name
argument does not represent any file on the NQA client. When you execute the
Use the command...
system-view
nqa entry admin-name
operation-tag
type http
destination ip ip-address
source ip ip-address
operation { get | post }
url url
Remarks
Optional
group"
Remarks
—
—
Required
Required
By default, no destination IP address is
configured.
Optional
By default, no source IP address is
specified.
The source IP address must be the IP
address of a local interface. The local
interface must be up; otherwise, no probe
packets can be sent out.
Optional
By default, the operation type for the HTTP
is get, which means obtaining data from
the HTTP server.
Required
123
file-name
of fixed size on the