Quick Setup - Christie Roadie HD+35K Setup Manual

Section 2: Installation and Setup
2.2

Quick Setup

1. Position the projector at an appropriate throw distance and vertical position from the screen. Make sure
that the projector is level from side-to-side, and is not inverted.
2. Securely fasten the ring terminal at the end of the earth wire to the building ground.
NOTE: A Christie accredited service technician must verify that the earth wire is properly grounded, prior
to powering up the projector or connecting to the lamp ballast.
3. Install the lens and the lamp. See
4. Connect an input source to a port on the input panel on the side of the projector.
5. Install the lamp ballast so the 4 cables reach the rear of the projection head.
6. Connect the lamp ballast to the projector:
2-2
Section 2.4 Installing Lens, Lamp, and Cooling.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)