Power Cords And Attachments; Lamp Precautions - Christie Roadie HD+35K Setup Manual

Section 1: Introduction

1.1.2 Power Cords and Attachments

NOTICE: Use only the attachments and accessories recommended by Christie. Use of unapproved attachments or
accessories may result in the risk of fire, shock, and personal injury.

1.1.3 Lamp Precautions

Protective Clothing
Never open the lamp door unless you are wearing protective clothing such as that included in a Christie
Protective Clothing Safety Kit (P/N: 598900-095). Recommended protective clothing includes, but may not be
limited to a polycarbonate face shield, protective gloves, and a quilted ballistic nylon jacket or a welder's
NOTE:
jacket. Christie's protective clothing recommendations are subject to change. Any local or federal
specifications take precedence over Christie recommendations.
Cool the Lamp Completely
1-2
Connect the Christie-supplied line cord to your AC Supply. Do not substitute
other cords. At the projection head, install the power cord retaining clip onto
the power cord. The power cord and retaining clip provide a reliable ground
and protect against electrical shock in the event of an electrical fault. This
product can be connected to an IT power distribution system.
EXPLOSION HAZARD! Wear authorized protective safety gear whenever the
lamp door is open! Never attempt to remove the lamp directly after use. The
lamp is under significant pressure when hot and cold, and may explode,
causing personal injury and/or property damage.
Lamp may explode causing bodily harm or death. Always wear protective
clothing whenever lamp door is open or while handling lamp. Ensure those
within the vicinity of the projector are also suited with protective clothing.
Never attempt to access the lamp while the lamp is ON. Wait at least 15
minutes after the lamp turns OFF before powering down, turning off the
breakers/power switches, disconnecting from AC and opening the lamp door.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)