Built In Keypad; Projector On, But No Backlight On Built-In Keypad; Image Displays; Blank Screen, No Display Of Image - Christie Roadie HD+35K Setup Manual

4.4

Built In Keypad

4.4.1 Projector ON, but No Backlight on Built-In Keypad

Check the following:
• Confirm the harness is plugged into the back of the built-in keypad (via the lamp compartment door).
• Touch any key. The backlight for the displays and keys should be present.
4.5

Image Displays

The following troubleshooting entries assume the use of a third-party input source. Before proceeding, consult
the documentation supplied with the external equipment.

4.5.1 Blank Screen, No Display of Image

Check the following:
• Confirm all connections are OK.
• Ensure the lens cap is not on the lens.
• Ensure the shutter is OPEN. Press S
• Ensure a full black test pattern IS NOT selected for display.

4.5.2 Severe Motion Artifacts

Most likely there is a synchronization problem with reversed 3-2 drop-down in 60 to 24 Hz film-to-digital
conversion in your source. The display file needs correction.

4.5.3 Image Appears Vertically Stretched or 'Squeezed' into Center of Screen

Source data converted from film and "pre-squeezed" for Roadie HD+35K display format may require use of an
anamorphic lens (or resizing) to regain full "scope" image width and proper proportions.

4.5.4 The Projector is ON, but There is No Display

Check the following:
• Ensure the lens cap is not on the lens.
• Ensure shutter is OPEN.
• If the lamp is not ignited, press L
• Ensure AC power is connected and power switch is ON.
• Is an active source connected properly? Check the cable connections and ensure the alternative source is
selected.
• Can you access test patterns? If so, check source connections again.
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)
HUTTER OPEN on the standard IR remote or built-in keypad to open.
ON from the standard IR remote or built-in keypad.
AMP
Section 4: Troubleshooting
4-3