Christie Roadie HD+35K Setup Manual page 15

7. Connect the projector power cord to an AC supply and turn breaker switch on.
The projector is now in standby mode. The voltmeter displays the incoming voltage, the PROJ. STATUS
light is yellow, and the light engine compartment fans are running.
NOTE: Use only the locking type AC power cord that is provided with the projector.
8. Set the lamp type:
a. Press M
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)
Figure 2-3 Connecting the Projection Head to AC
Do not operate the projection head if the AC level is not within the specified
voltage and power range.
Explosion hazard. Keep the projection head off until you define the lamp type
installed.
.
ENU
Section 2: Installation and Setup
2-5