Christie Roadie HD+35K Setup Manual page 24

Section 2: Installation and Setup
IMPORTANT! The following steps are necessary to ensure your safety and that the lens does not fall out.
4. Lock the lens assembly in place with the lens clamp DOWN.
5. For added security, tether the lens to the projector by wrapping it around
either the handle or FredFrame™ if flown. This step is not required if the
projector is floor-mounted.
6. Remove the front lens cap.
7. Calibrate the lens. See
Operation in the Roadie HD+35K User Manual.
To calibrate the lens, select the Configuration > Diagnostics and Calibration > ILS Calibration >
Reference Calibration option from the Main menu. This allows the lens to find the center points of each axis
(focus, zoom, horizontal, and vertical), the end stops, and other motion parameters.
NOTE: Failure to calibrate the lens can cause damage to the lens mount.
Lens Center Command
This command moves the lens horizontal and vertical motion to the center of travel.
NOTES: 1) The lens seals the projection head, preventing contaminants from entering the area of main
electronics. Never attempt to operate the projector without a lens installed. During transport and installation,
install a lens plug. 2) Always re-install a lens in its previous "UP" orientation, otherwise boresight may
require re-adjustment.
2-14
In the event a lens is dropped, the lens tether and
clamp assembly
therefore must be replaced before continuing its
use. Failure to do so could result in injury or death.
Figure 2-9. For more information, see Section 3,
Lens calibration must be performed each time a new lens is inserted or after
performing manual lens mount adjustments. To calibrate the lens, select the
Configuration > Diagnostics and Calibration > ILS Calibration > Reference
Calibration option from the Main menu. This is critical to the projector
functioning properly. Failure to do so could result in damage to the lens
mount, the projector, or the projection lens.
Figure 2-9 Diagnostic and Calibration Menu
may become stressed, and
Figure 2-8 Tether Lens to
Projector
Roadie HD+35K Setup Guide
020-100394-06 Rev. 1 (10-2013)