Tools And Material - Allied Telesis x530L Series Installation Manual

Tools and
The following tools and material are required for installing the switch on
a wall.
Material
Included with switch:






Not included with switch:





Wall/equipment rack brackets:
– Two for AT-x530L-28GTX and AT-x530L-52GTX
– Four for AT-x530L-28GPX and AT-x530L-52GPX
Screws for attaching wall/equipment rack brackets:
– Eight for AT-x530L-28GTX and AT-x530L-52GTX
– Sixteen for AT-x530L-28GPX and AT-x530L-
52GPX
Length: 6.0mm (0.2 in.) Diameter: 4.0mm (0.2 in.)
Anchors for concrete walls:
– Two for AT-x530L-28GTX and AT-x530L-52GTX
– Four for AT-x530L-28GPX and AT-x530L-52GPX
Length: 29.6mm (1.2 in.) Diameter: 6.0mm (0.2 in.).
Screws for wood or concrete walls
– Two for AT-x530L-28GTX and AT-x530L-52GTX
– Four for AT-x530L-28GPX and AT-x530L-52GPX
Length: 32mm (1.3 in.) Diameter: 4mm (0.2 in.)
Two power cord retaining clips
Four rubber bumper feet
Cross-head screwdriver.
Stud finder for a wooden wall, capable of identifying the middle of
wall studs and hot electrical wiring.
Drill and 1/4-inch carbide drill bit (for a concrete wall).
Refer to "Installing the Switch on a Concrete Wall" on page 80.
Plywood base (if you are installing the switch on a wall with
wooden studs). Refer to "Plywood Base for a Wall with Wooden
Studs" on page 71 for illustrations.
Four screws for attaching the plywood base to the wall.
x530L Series Installation Guide for Stand-alone Switches
69