Chapter 6: Powering On the Switch
Powering On the Switch
84
Before powering on the switch, review the information in "Power
Specifications" on page 116 for the power specifications.
Warning
The power cord is used as a disconnection device. To de-energize
equipment, disconnect the power cord. E3
Note
Pluggable Equipment. The socket outlet shall be installed near the
equipment and shall be easily accessible. E5
To power on the switch, perform the following procedure:
1. Install the power cord retaining clip on the AC power connector on the
rear panel of the switch. Refer to Figure 37.
Figure 37. Installing the Power Cord Retaining Clip
2. Connect the AC power cord to the AC power connector on the rear
panel. Refer to Figure 38 on page 85.