Installing The Switch On A Plywood Base - Allied Telesis x530L Series Installation Manual

Installing the Switch on a Plywood Base

After the plywood base for the switch has been installed on the wall, install
the switch. See "Reviewing Safety Precautions" on page 46 and
"Choosing a Site for the Switch" on page 51 before performing this
procedure. Allied Telesis recommends a minimum of two people for this
procedure.
Warning
The device is heavy. Always ask for assistance before moving or
lifting it to avoid injuring yourself or damaging the equipment.
Warning
The device should be installed on the wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment can result if it is not properly fastened to the wall. 
E105
To install the switch on the plywood base, perform the following procedure:
1. Place the switch on a table.
2. For the AT-x530L-28GTX and AT-x530L-52GTX switches, install two
wall/equipment rack brackets to the sides of the unit with the eight
M4x6mm screws included with the switch. Install the brackets
diagonally across from each other on opposite corners of the switch.
Refer to Figure 31 on page 76. For the AT-x530L-28GPX and AT-
x530L-52GPX switches, install 4 wall/equipment rack brackets to the
sides of the unit with the 16 M4x6mm screws included with the switch.
Refer to Figure 32 on page 77.
Note
The AT-x530L-28GPX and AT-x530L-52GPX require four brackets
to be installed due to its weight. Whereas, the AT-x530L-28GTX and
AT-x530L-52GTX only requires two brackets because it is lighter.
x530L Series Installation Guide for Stand-alone Switches
75