Figure 40: Connecting The Power Cords To An Ac Power Source - Allied Telesis x530L Series Installation Manual

Chapter 6: Powering On the Switch
86
5. Repeat steps 1 to 3 to connect a power cord to the second power
supply.
6. Connect the power cords to an appropriate AC power source. Refer to
Figure 40 on page 86.
Figure 40. Connecting the Power Cords to an AC Power Source
Note
The illustration shows a North American power cord. Your power
cords may be different.
7. Do one of the following:
To monitor the switch as it initializes the management software, go

to "Monitoring the Initialization Processes" on page 87.
Wait two minutes for the switch to initialize its management

software and then go to Chapter 7, "Configuring the Switch for
Stand-alone Operations" on page 91.