Table of Contents
Advertisement
Maintaining the Sprayer
and Spreader Systems
Check Sprayer System
Service Interval: Every 50 hours
1.
Stop engine, wait for all moving parts to stop,
and remove key. Engage parking brake.
2.
Check all hoses, nozzles, and fittings for leaks.
3.
Check nozzle strainers and in-line strainers.
4.
Replace as needed.
Check In-line Filter
Periodically check the in-line filter for any debris in
the screen. If debris is present, this can create erratic
pressure spikes and/or not allow the proper flow
through system. After clearing any debris, ensure that
gasket remains intact and tighten in-line filter cap (if
not installed properly, this will allow air to get in the
system and system will lose or not create pressure).
Figure 47
1. Cap
2. Filter
Check Spreader System
Service Interval: Every 50 hours
Clean the bottom of the hopper with a wire brush and
clean off any fertilizer if needed.
g397886
3. Gasket
4. In-line filter housing
Change out the hopper bottom bushing or the impeller
if needed.
54
Advertisement
Table of Contents
