Lubrication; Greasing The Machine; Greasing The Sprayer Pump - Toro MultiPro 1750 Operator's Manual

Lubrication

Greasing the Machine

Service Interval: Every 100 hours/Yearly (whichever
comes first)—Lubricate all grease
fittings.
Grease Type: No. 2 lithium grease
Refer Figure 36 for the grease-point locations.
Figure 36
1. Wipe the grease fitting clean so that you do not
force dirt or debris into the bearing or bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off the excess grease.

Greasing the Sprayer Pump

Service Interval: Every 50 hours—Lubricate the
pump.
Grease Type: Mobil XHP 461
1. Raise the sprayer; refer to
(page 44).
2. Locate the sprayer pump.
Note:
The pump is located below the seat; refer
to Locating the Spray Pump (page
3. Wipe the 2 remote grease fittings clean
37A and Figure 37B).
g216476
Raising the Sprayer
30).
(Figure
45
Figure 37
1. Grease fitting (outboard
side of the spray pump)
2. Grease fitting (bottom,
rear side of the spray
pump)
4. Pump grease into each remote grease fitting
(Figure 37A and Figure
5. Wipe off the excess grease.
g216324
g216325
3. Front of the machine
37B).