Replacing Enclosure End Caps - IBM Storwize V7000 Unified Problem Determination Manual

Figure 50. Removing the 2.5" drive
4. Pull out the drive.
5. Push the new drive back into the slot until the handle starts to move.
6. Finish inserting the drive by closing the handle until the locking catch clicks

Replacing enclosure end caps

To replace enclosure end caps, use this procedure.
About this task
Attention: The left end cap is printed with information that helps identify the
enclosure.
v machine type and model
v enclosure serial number
v its machine part number
The information on the end cap should always match the information printed on
the rear of the enclosure, and it should also match the information that is stored on
the enclosure midplane.
Procedure
To remove and replace either the left or right end cap, complete the following
steps.
1. If the enclosure is on a table or other flat surface, elevate the enclosure front
2. Grasp the end cap by the blue touch point and pull it until the bottom edge of
3. Lift the end cap off the chassis flange.
230
Storwize V7000 Unified: Problem Determination Guide 2073-720
into place.
slightly or carefully extend the front over the table edge.
the end cap is clear of the bottom tab on the chassis flange.