IBM Storwize V7000 Unified Problem Determination Manual page 147

Power supplies
4. Slide the power supply into the bay until the retention latch clicks into place.
Attention: Do not install the different power rating or wattage of power
supplies, high-efficiency and non-high-efficiency power supplies in the server.
5. Connect the power cord for the new power supply to the power-cord connector
on the power supply.
The following illustration shows the power-cord connectors on the back of the
server.
6. Route the power cord through the clip next to power-supply and through any
cable clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
7. Connect the power cord to a properly grounded electrical outlet.
8. Make sure that the error LED on the power supply is not lit, and that the ac
power LED on the power supply are lit, indicating that the power supply is
operating correctly.
9. If you are replacing a power supply with one of a different wattage, apply the
power information label provided with the new power supply over the existing
power information label on the server.
xxx-xxx/xxx-xxx
x,x/x,x
xx/xx Hz
Product certified in Shenzhen China
Made in China
xxx-xxx/xxx-xxx
x,x/x,x
xx/xx Hz
:
Manufacturer IBM Corporation
Copyright Code and Parts Contained Herein.
.
©Copyright IBM Corp 2010 All Rights Reserved
/ - /
Canada ICES NMB 003 Class Classe A
XXXW ~ AC
1
xxx-xxx/
xxx-xxxV~
x,x/x,x A
xx/xx Hz
Power cord
connectors
,
V
.
XXXW ~ AC
2
xxx-xxx/
xxx-xxxV~
x,x/x,x A
xx/xx Hz
- - -
KCC REM IBC 7915
Chapter 4. File module
XXXX
xxx
127