Removing The Bezel - IBM Storwize V7000 Unified Problem Determination Manual

Figure 14. Installing the cover
Procedure
1. Make sure that all cables, adapters, and other components are installed and
2. Place the cover-release latch in the open (up) position.
3. Insert the bottom tabs of the top cover into the matching slots in the file
4. Press down on the cover-release latch to lock the cover in place.
5. Slide the file module into the rack until it latches.
6. Follow the steps at the end of the procedure in "Removing a file module and

Removing the bezel

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove the bezel, complete the following steps.
1
2
Cover-release
latch
seated correctly and that there are no loose tools or parts inside the file module.
Also, ensure that all internal cables are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on
the front, rear, and side of the cover engage the chassis correctly. If all the tabs
do not engage the chassis correctly, it can cause difficulty in removing the cover
later on.
module chassis.
disconnecting power" on page 58 to suspend the file module to reconnect the
file module and resume its use in the cluster.
91
Chapter 4. File module