IBM Storwize V7000 Unified Problem Determination Manual page 90

Mirror Information:
NOTICE: The mirror is not created/configured.
Drive Information:
Total number of drives found: 2
Target on ID #4
Device is a Hard disk
Enclosure #
Slot #
Connector ID
Target ID
State
Size (in MB)/(in sectors)
Manufacturer
Model Number
Firmware Revision
Serial No
Drive Type
Protocol
Error Information
SMART Error Count
SMART ASC
SMART ASCQ
Target on ID #6
Device is a Hard disk
Enclosure #
Slot #
Connector ID
Target ID
State
Size (in MB)/(in sectors)
Manufacturer
Model Number
Firmware Revision
Serial No
Drive Type
Protocol
Error Information
SMART Error Count
SMART ASC
SMART ASCQ
Figure 11. Example that shows that the mirror is not created
8. See Figure 12 on page 71 for an example of a Self-Monitoring, Analysis and
70
Storwize V7000 Unified: Problem Determination Guide 2073-720
: 1
: 1
: 1
: 4
: Ready (RDY)
: 286102/585937500
: IBM-ESXS
: XXXXXXXXXXXX
: XXXX
: XXXXXXXXXXXXXXXXXXXX
: SAS
: SAS
: none
: none
: none
: 1
: 0
: 0
: 6
: Ready (RDY)
: 286102/585937500
: IBM-ESXS
: XXXXXXXXXXXX
: XXXX
: XXXXXXXXXXXXXXXXXXXX
: SAS
: SAS
: none
: none
: none
Reporting Technology (SMART) error found for a hard drive. SMART adds
monitoring and troubleshooting functionality by automatically checking a disk
drive's health and reporting potential problems. If any SMART errors are
detected for a hard drive, you can see the status in the section for Error
Information as shown in Figure 12 on page 71.
Note: In Figure 12 on page 71 the hard disk drive with Target ID #6 has a
ASC/ ASCQ error of 05/00.
For isolation and the repair of hard disk problems, refer to "Troubleshooting
the System x3650" in the IBM Storwize V7000 Unified Information Center.
For a list of SMART (ASC/ASCQ) error codes and their descriptions, go to
"SMART ASC/ASCQ error codes and messages" on page 71.
<---