IBM Storwize V7000 Unified Problem Determination Manual page 298

278
Storwize V7000 Unified: Problem Determination Guide 2073-720
Table 43. Upgrade error codes from using the applysoftware command and recommended
actions (continued)
Error Code
EFSSG4105
EFSSG4105C
EFSSG4106A
EFSSG4153
EFSSG4154
EFSSG4154A
EFSSG4155
EFSSG4155I
EFSSG4156
EFSSG4156A
The applysoftware
command explanation
Unable to mount the USB
flash drive.
The applysoftware command
returned unable to mount
USB.
The applysoftware command
returned that there is
insufficient system file
system space.
The required parameter was
not specified.
You must start on primary
management node
mgmt001st001.
The applysoftware returned
must start on primary
management node
mgmt001st001.
Unable to mount USB flash
drive.
The applysoftware command
returned upgrade is already
running.
The specified International
Organization for
Standardization (ISO) does
not exist.
The applysoftware command
returned the specified ISO
does not exist.
Action
Run umount /media/usb, then
remove the USB flash drive.
Reinsert the USB flash drive.
If the error persists, remove
the USB flash drive and
reboot. After the system
reboots, reinsert the USB
flash drive.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
Switch to the other node and
try the command again.
Back up to a USB flash drive.
Enter #
backupmanagementnode
--unmount /media/usb.
Remove the USB flash drive
and insert again. If the error
persists, remove the USB
flash drive and reboot. When
the system is running, insert
the USB flash drive again.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.