IBM Storwize V7000 Unified Problem Determination Manual page 142

About this task
Attention:
dual-motor hot-swap fan with the system running, you must install a replacement
dual-motor hot-swap fan within 30 seconds or the system will shut down.
To remove any of the three replaceable dual-motor hot-swap fans, complete the
following steps.
Procedure
1. Read the Safety information and "Installation guidelines" on page 60.
2. Leave the file module connected to power.
3. Slide the file module out of the rack and remove the cover (see "Removing the
4. Grasp the dual-motor hot-swap fan by the finger grips on the sides of the
5. Rotate the air baffle up.
6. Lift the dual-motor hot-swap fan out of the file module.
7. Replace the dual-motor hot-swap fan within 30 seconds.
122
Storwize V7000 Unified: Problem Determination Guide 2073-720
To ensure proper file module operation and cooling, if you remove a
Fan 3
Fan 2
cover" on page 89). The LED on the system board near the connector for the
failing dual-motor hot-swap fan will be lit.
Attention: To ensure proper system cooling, do not remove the top cover for
more than 30 minutes during this procedure.
dual-motor hot-swap fan.
Vertical tabs
Fan 1