IBM Storwize V7000 Unified Problem Determination Manual page 196

Apply software command:
Use this command to install a specific upgrade package on the node canister.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
Parameters
-file
-ignore
Description
This command copies the file from the USB flash drive to the upgrade directory on
the node canister and then installs the upgrade package.
This command calls the satask installsoftware command.
Create system command:
Use this command to create a storage system.
Note: The reference to cluster is not the same as the file system cluster on the
Storwize V7000 file modules.
Attention: Run this command only when instructed by IBM support. Running
this command directly on a Storwize V7000 can affect your I/O operations on the
file modules.
Syntax
176
Storwize V7000 Unified: Problem Determination Guide 2073-720
satask installsoftware
(Required) The file name of upgrade package .
(Optional) Overrides prerequisite checking and forces installation of the
upgrade package.
satask mkcluster -clusterip
-name cluster_name
satask mkcluster -clusterip_6
-name cluster_name
-file filename
ipv4
-gw ipv4
ipv6
-gw_6 ipv6
-ignore
-mask ipv4
-prefix_6 int