Removing The Cover - IBM Storwize V7000 Unified Problem Determination Manual

Removing the cover

The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove the cover, complete the following steps.
Figure 13. Removing the cover
Table 30. Components identified as customer replaceable units (CRUs) and field
replaceable units (FRUs) (continued)
Types of Explanation of
replaceable each type of
parts replaceable part
Field replaceable FRUs must be
units (FRUs) installed only by
trained service
technicians.
3
2
1
Cover-release
latch
Procedures categorized under each type of
replaceable part
"Installing the 240 VA safety cover" on page 94
"Removing a microprocessor and heat sink" on page
131
"Installing a microprocessor and heat sink" on page
135
"Removing and replacing the thermal grease" on
page 139
"Removing a heat-sink retention module" on page
141
"Installing a heat-sink retention module" on page
141
"Removing the system board" on page 142
"Installing the system board" on page 144
"Setting the machine type, model, and serial
number" on page 147
89
Chapter 4. File module