IBM Storwize V7000 Unified Problem Determination Manual page 194

Syntax
Parameters
-serviceip
-gw
-mask
-serviceip_6
-gw_6
-default
-prefix_6
-resetpassword
Description
This command resets the service assistant IP address to the default value. If the
command is run on the upper canister, the default value is 192.168.70.121 subnet
mask: 255.255.255.0. If the command is run on the lower canister, the default value
is 192.168.70.122 subnet mask: 255.255.255.0. If the node canister is active in a
system, the superuser password for the system is reset; otherwise, the superuser
password is reset on the node canister.
If the node canister becomes active in a system, the superuser password is reset to
that of the system. You can configure the system to disable resetting the superuser
password. If you disable that function, this action fails.
This action calls the satask chserviceip command and the satask resetpassword
command.
174
Storwize V7000 Unified: Problem Determination Guide 2073-720
satask chserviceip -serviceip ipv4
satask chserviceip -serviceip_6 ipv6
-resetpassword
satask chserviceip
(Optional) The IPv4 address for the service assistant.
(Optional) The IPv4 gateway for the service assistant.
(Optional) The IPv4 subnet for the service assistant.
(Optional) The IPv6 address for the service assistant.
(Optional) The IPv6 gateway for the service assistant.
(Optional) Resets to the default IPv4 address.
(Optional) The IPv6 prefix for the service assistant.
(Optional) Sets the service assistant password to the default value.
-gw ipv4 -mask ipv4
-gw_6 ipv6
-default
-resetpassword
-resetpassword
-prefix_6 int