IBM Storwize V7000 Unified Problem Determination Manual page 149

About this task
To install the replacement operator information panel assembly, complete the
following steps.
Operator information
panel
Procedure
1. Read the Safety information and "Installation guidelines" on page 60.
2. Position the operator information panel assembly so that the tabs face upward
and slide it into the file module until it clicks into place.
3. Inside the file module, connect the cable to the rear of the operator information
panel assembly.
4. Install the cover (see "Installing the cover" on page 90).
5. Slide the file module into the rack.
6. Follow the steps at the end of the procedure "Removing a file module and
disconnecting power" on page 58 to reconnect the file module and resume its
use in the cluster.
Removing the hot-swap drive backplane
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
About this task
To remove the hot-swap drive backplane, complete the following steps.
129
Chapter 4. File module