IBM Storwize V7000 Unified Problem Determination Manual page 166

About this task
To reinstall the system board, complete the following steps.
Procedure
146
Storwize V7000 Unified: Problem Determination Guide 2073-720
Pin
1. Align the system board at an angle, as shown in the illustration; then, rotate
and lower it flat and slide it back toward the rear of the file module. Make
sure that the rear connectors extend through the rear of the chassis.
2. Reconnect to the system board the cables that you disconnected in step 10 on
page 143 of "Removing the system board" on page 142.
3. Rotate the system-board thumbscrews toward the rear of the file module until
the latch clicks into place.
4. Install the fans.
5. Install each microprocessor with its matching heat sink (see "Installing a
microprocessor and heat sink" on page 135).
6. Install the DIMMs (see "Installing a memory module" on page 119).
Thumbscrew