Replacing An Enclosure End Cap; Replacing A Sas Cable; Removing The 2.5" Drive - IBM Storwize V7000 Maintenance Manual

Figure 37. Removing the 2.5" drive
4. Pull out the drive.
5. Push the new drive back into the slot until the handle starts to move.
6. Finish inserting the drive by closing the handle until the locking catch clicks

Replacing an enclosure end cap

This topic describes how to replace an enclosure end cap.
To replace the enclosure end cap, perform the following steps:
1. On either side of the drive assemblies, remove the enclosure end caps by
2. Reattach the end cap by relocating it on either side of the drive assemblies and

Replacing a SAS cable

This topic describes how to replace a SAS cable.
Be careful when you are replacing the hardware components that are located in the
back of the system that you do not inadvertently disturb or remove any cables that
you are not instructed to remove.
To replace a SAS cable, perform the following steps:
1. Record which SAS cable is plugged into the specific port of the expansion
into place.
squeezing the middle of the cap and pulling it away from the front of the rack.
gently pushing it on.
canister. The cable must be inserted back into the same port after the
replacement is complete; otherwise, the system cannot function properly.
Note: If you are replacing a single cable, this step is not necessary.
Chapter 8. Removing and replacing parts
99