IBM Storwize V7000 Unified Problem Determination Manual page 114

5. Remove the screw from the safety cover.
6. Disconnect the hard disk drive backplane power cables from the connector in
7. Slide the cover forward to disengage it from the system board, and then lift it
8. If you are instructed to return the 240 VA safety cover, follow all packaging
Installing the 240 VA safety cover
The following procedure is for a Tier 1 customer replaceable unit (CRU).
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation. Service agreements can be
purchased so that you can ask IBM to replace these units.
To install the 240 VA safety cover, complete the following steps.
94
Storwize V7000 Unified: Problem Determination Guide 2073-720
Safety cover
front of the safety cover.
out of the file module.
instructions, and use any packaging materials for shipping that are supplied to
you.
Screw