Replacing An Enclosure End Cap; Replacing A Sas Cable; Removing The 2.5" Drive - IBM Storwize V7000 Troubleshooting And Maintenance Manual

Figure 34. Removing the 2.5" drive
4. Pull out the drive.
5. Push the new drive back into the slot until the handle starts to move.
6. Finish inserting the drive by closing the handle until the locking catch clicks into place.

Replacing an enclosure end cap

This topic describes how to replace an enclosure end cap.
To replace the enclosure end cap, perform the following steps:
1. On either side of the drive assemblies, remove the enclosure end caps by squeezing the middle of the
cap and pulling it away from the front of the rack.
2. Reattach the end cap by relocating it on either side of the drive assemblies and gently pushing it on.

Replacing a SAS cable

This topic describes how to replace a SAS cable.
Be careful when you are replacing the hardware components that are located in the back of the system
that you do not inadvertently disturb or remove any cables that you are not instructed to remove.
To replace a SAS cable, perform the following steps:
1. Record which SAS cable is plugged into the specific port of the expansion canister. The cable must be
inserted back into the same port after the replacement is complete; otherwise, the system cannot
function properly.
Note: If you are replacing a single cable, this step is not necessary.
2. Pull the tab with the arrow away from the connector.
Chapter 8. Removing and replacing parts
103