IBM Storwize V7000 Unified Problem Determination Manual page 167

7. Install the air baffle (see "Installing the air baffle" on page 104), making sure
that all cables are out of the way.
8. If necessary, install the Ethernet adapter.
9. If necessary, install the virtual media key.
10. Install the PCI riser-card assemblies and all adapters (see "Installing a PCI
riser-card assembly" on page 108).
11. Install the cover (see "Installing the cover" on page 90).
12. Push the power supplies back into the file module.
13. Slide the file module into the rack.
14. Follow the steps at the end of the procedure "Removing a file module and
disconnecting power" on page 58 to reconnect the file module and resume its
use in the cluster.
Results
Important: Perform the following updates:
v Start the Setup utility and reset the configuration.
– Set the system date and time.
– Set the power-on password.
– Reconfigure the file module.
v Either update the file module with the latest RAID firmware or restore the
pre-existing firmware from a diskette or CD image.
v Update the UUID.
v Update the DMI/SMBIOS.
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest level of
code is supported for the cluster solution before you update the code.
Setting the machine type, model, and serial number
This procedure is for IBM authorized service providers who, after replacing a
system board in one of the file modules, must reset the machine type, model, and
serial number vital product data using the Advanced Settings Utility (ASU). The
following procedure is for a field replaceable unit (FRU). FRUs must be installed
only by trained service technicians.
About this task
The ASU package is part of the Storwize V7000 Unified code. ASU is available to
authorized service personnel from the command-line interface (CLI) on the file
module. Use ASU to modify selected settings in the integrated-management-
module (IMM)-based Storwize V7000 Unified file modules.
You can use the ASU remotely from your laptop (if allowed) or from a file module
that has Storwize V7000 Unified installed.
Procedure
1. Access and log in to the Storwize V7000 Unified system from the CLI.
2. Issue the following command to view the current settings for the machine type
and model:
asu show SYSTEM_PROD_DATA.SysInfoProdName
147
Chapter 4. File module