IBM Storwize V7000 Unified Problem Determination Manual page 39

Table 7. Error messages and actions (continued)
Error code Error message
0B95 Invalid parameters.
0B96 Failed to configure the management processes on
mgmt001st001
0B97 IP is invalid.
0B98 Netmask is invalid.
0B99 IP, gateway, and netmask are not a valid
combination.
0B9A There was an internal error.
0B9B Invalid NAS private key file.
0B9C Unable to copy the NAS private key file.
0B9D Internal error setting permissions on NAS private
key file.
0B9E No NAS private key file found. Verify that the
Storwize V7000 configuration ran properly.
0B9F Unable to find local serial number in new nodes.
0BA0 Unable to find node at new IP address. Check the
node cabling.
0BA1 Remote node is at a higher code level.
0BA2 Management IP for node not found.
0BA3 The disk IP was not found in VPD.
0BA4 Unable to attach to Storwize V7000 system. Private
key files might not match.
0BA5 Unable to add Storwize V7000 system to CLI.
0BA6 The addstoragesystem CLI command has failed.
0BAC Unable to find remote serial number in newnodes.
0BAD Remote node is at a higher code level.
0BAE Incorrect parameters.
0BAF Unable retrieve the node serial number.
0BCC Unable to configure policy routing
0BB0 Unable to open pxeboot data file.
0BB1 Unable to update pxeboot data file for node.
0BB2 Unable to set file permissions.
0BB3 Unable to find node serial in pxeboot data file.
0BB4 Node had an internal error during configuration.
0BC6 Unable to configure system.
0BC9 Invalid arguments passed to the script.
01B2 Unable to start performance collection daemon.
01B3 Failed to copy upgrade package to Storwize V7000
system.
01B4 Failed to start upgrade on Storwize V7000 with the
svctask applysoftware command.
01B5 Storwize V7000 multipaths are unhealthy.
Action key
D
D then A then B
D
D
D
A
F
F
A
F
B
C
E
D
D
G then F
A
G then D
C then D then B
E
A
A
D then C then B
A
A
A
A
A
A
A
Contact IBM Remote
Technical Support.
H then G
H then G then I
H then G
Chapter 3. Getting started troubleshooting
19