Management Gui Interface; About This Task - IBM Storwize V7000 Unified Problem Determination Manual

Management GUI interface

The management GUI is a browser-based GUI for configuring and managing all
aspects of your system. It provides extensive facilities to help troubleshoot and
correct problems.

About this task

You use the management GUI to manage and service your system. The Monitoring
> Events panel provides access to problems that must be fixed and maintenance
procedures that step you through the process of correcting the problem.
Two tabs are available for monitoring events:
v A Block tab for monitoring the SAN volume events and the file system volume
v A File tab for monitoring the NAS events from theStorwize V7000 Unified file
When you click the Block tab, a Next recommended action is shown. Perform the
next recommended action before attempting any other recommended actions.
The information on the Events panel can be filtered three ways:
Recommended action (default)
Unfixed messages and alerts
Table 20. Control enclosure battery LEDs (continued)
Battery Good Battery Fault
+ - + -
Off On
Off Flashing
Flashing Flashing
events from the control enclosure.
modules.
Shows only the alerts that require attention. Alerts are listed in priority
order and should be fixed sequentially by using the available fix
procedures. For each problem that is selected, you can:
v Run a fix procedure.
v View the properties.
Displays only the alerts and messages that are not fixed. For each entry
that is selected, you can:
v Run a fix procedure.
v Mark an event as fixed.
v Filter the entries to show them by specific minutes, hours, or dates.
v Reset the date filter.
v View the properties.
Description
Nonrecoverable battery fault.
Recoverable battery fault.
The battery cannot be used
because the firmware for the
power supply unit is being
downloaded.
Chapter 3. Getting started troubleshooting
Action
Replace the battery. If
replacing the battery
does not fix the issue,
replace the power supply
unit.
None
None
53