IBM Storwize V7000 Unified Problem Determination Manual page 192

www.ibm.com/storage/support/storwize/v7000/unified
Procedure
To use the initialization tool, complete the following steps.
1. If you downloaded the initialization tool, copy the file onto the USB flash drive
2. To start the initialization tool, insert the USB flash drive that contains the
3. Run the InitTool.exe program from the USB drive.
4. After the satask.txt file is created, follow the instructions in "Using a USB
5. When the commands have run, return the USB flash drive to your personal
USB memory key has incorrect gateway address information
If the link on the InitTool panel to the management GUI does not work, the USB
key may have an incorrect gateway address.
About this task
The InitTool.exe may indicate that the initial setup was successful, however, the
link on the InitTool panel to the management GUI may not work. Given this
scenario, it is possible that you have entered a management gateway IP address
that is in the same subnet as the management IP address but is not the IP address
of the gateway for this subnet. To check this, look inside the satask.exe file on the
USB flash drive and note the IP address after the -gw switch. Make sure this IP
address is the gateway for this subnet. If an IP address is needed then check this
with your 1 Gbps Ethernet administrator.
If you did enter the wrong IP address for the gateway of this subnet and you have
the correct gateway IP address ready, then it is possible to re-configure the control
enclosure and file module to use the correct management gateway IP address.
If you have access to a computer that is plugged into the same Ethernet switch as
the 1 Gbps Ethernet port 3 of each file module and the 1 Gbps Ethernet port 1 of
each node canister in the control enclosure, then you may be able to ssh from it to
the management IP address and log on as admin.
In this example, the default password is admin:
ssh admin@<management IP address>
172
Storwize V7000 Unified: Problem Determination Guide 2073-720
that you are going to use.
program into a USB slot on a suitable personal computer.
v Windows: Open the USB flash drive and double-click InitTool.bat.
v Apple Macitosh: Locate the root directory of the USB flash driv (usually
located in the /Volumes/ directory). Type sh InitTool.sh.
v Linux: Locate the root directory of the USB flash drive. (It is usually located
in the /media/ directory. If an automatic mount system is used, the root
directory can be located by typing the mount command.) Type sh
InitTool.sh.
The initialization tool prompts you for the task that you want to perform and
for the parameters that are relevant to that task. It prompts you when to put it
in the node canister on the control enclosure.
flash drive" on page 170 to run the commands on the node.
computer and start the tool again to see the results.