IBM Storwize V7000 Unified Problem Determination Manual page 40

20
Storwize V7000 Unified: Problem Determination Guide 2073-720
Table 7. Error messages and actions (continued)
Error code Error message
01B6 Storwize V7000 volumes are unhealthy as indicated
using the lsvdisk command.
01B7 Failed to query status of upgrade by using the
lssoftwareupgradestatus command.
01B9 Failed to check the Storwize V7000 version
01B8 Failed to query status of Storwize V7000 nodes using
the lsnodes command.
O1BE Unable to distribute upgrade callback
01BF Upgrade callback failed
01CF Unable to configure node
01C4 Unable to remove callbacks
01D5 Storwize V7000 stalled.
01D6 Storwize V7000 stalled_non_redundant
01DA GPFS cluster is unhealthy
01DB Failed to stop performance center
Action key
Check Fibre Channel
cabling to storage and
verify storage is up.
H then G
H
H
Check on health of
the cluster using
lshealth
Contact IBM Remote
Technical Support.
Contact your
customer advocate.
Upgrade callbacks are
custom steps placed
on a system before the
start of upgrade.
Contact IBM Remote
Technical Support.
Pull both power
supply cables from
subject node, wait 10
seconds, plug back in,
after system comes up
try again.
Contact IBM Remote
Technical Support.
Contact IBM Remote
Technical Support.
H
Refer to "Checking
the GPFS file system
mount on each file
module" on page 155
Please attempt to stop
performance center
using
/opt/IBM/sofs/cli/
cfgperfcenter --stop.
If successful restart
upgrade. If you are
unable to stop
performance center
please contact IBM
Remote Technical
Support.